A very pleasing strong opaque green glaze which works well on all glaze bodies. This product fires between 1020°C & 1100°C (Cone 06 to Cone 04).
A very pleasing strong opaque green glaze which works well on all glaze bodies.
1020°C to 1100°C (Cone 06 to Cone 04). The sample shows one and two coats on Vitraclay, White Earthenware Clay, fired to 1040°C.
These notes are continuously updated so please send us your feedback.
Vitraglaze is lead free and non-toxic. Good housekeeping is essential in any pottery studio to minimise inhalation of silica dust. Always clean up with a damp sponge and if any dust is airborne, such as when mixing powder glazes, wear an FFP3 mask.
Preparing Powder Glaze:
Always wear a mask when mixing powdered glaze. Glaze should be added to water according to the instructions. Mix glaze for at least 10 minutes, sieve the liquid glaze using an 80 mesh screen, working all the material through the sieve using a stiff brush. The glaze mix should have a creamy viscosity, remember it’s easier to thin a glaze so begin with a thicker mix than you expect.
Applying Brush on Glaze:
Stir glaze thoroughly as components of glaze may settle, avoid shaking the pot as this may cause the lid to become difficult to open next time you use the glaze. Brush glaze using a flat well loaded brush, apply 2 to 3 even coats of glaze in different directions, one after the other.
Please note this glaze may contain traces of Biocides. More information on Biocides can be found here.